Even the best door underperforms if it isn't installed properly. We fit the track, hardware, and opener as one coordinated system, not separate pieces bolted together.
Putting in a new garage door takes a lot more than dropping a panel into an opening. The track needs to sit perfectly plumb, the springs must match the door's exact weight, and the opener's travel limits need calibrating to the new door's specific height and thickness. Skip any one of those steps and the whole system wears out faster, so we approach every installation as a complete setup, start to finish.
Before installation day arrives, we measure the rough opening, headroom, and available side room, since those numbers decide which door styles and track layouts will actually work in your garage. This step heads off the frustrating scenario where a door technically fits the opening but can't clear a low ceiling or a tight side wall.
On installation day, every hinge, roller, and track bracket is set and verified square before we touch the springs. A door hung even slightly out of square will drag against the weatherstripping, chew through rollers unevenly, and load the opener unevenly over time. We slow down at this stage on purpose — it's far less costly to get right the first time than to fix on a return visit.
Once the door is hung, we balance the springs so it holds its position on its own when disconnected from the opener, exactly as a well-installed door should. Only after that balance check passes do we hook up and calibrate the opener, then cycle the door repeatedly to confirm it runs smooth and quiet.
A typical single-door installation wraps up within a day, though the timeline shifts depending on whether the existing track and opener are staying or being swapped out along with the door.
Not necessarily. If your current opener is in solid shape and rated for the new door's weight, it can usually stay in place. We'll confirm this when we come out to measure.
The opening's width and height, the headroom above it, and the clearance on both sides all matter, since they determine which track and spring setup will actually work for your garage.
Reach ProGate Garage Door Service in Raymond, NH and talk with a technician about your garage door installation needs.
Call 1 (833) 652-7571